AQUATIC ACCESS INC.
 FOR ABOVE-GROUND POOLS & SPAS

Models SLE36 & SLE48 Spa Lift External, Lift over 36" & 48" Wall
  Usually Assisted Operation    Vertical seat travel -- SLE36 - 24"
 Manual 360° seat turn          Vertical seat travel -- SLE48 - 31 "
 Water pressure powered        Other applications include nursing home tubs
 Lift up to 300 lbs. at 55 psi    Portable
 The Spa Lift Models SLE36 (shown left) and SLE48 have 10"x10" stainless steel plates welded to the cylinder bottom which are bolted to the floor. The standard  seats face out and have no arms. Optional side seats and stationary handles (not shown) allow some people to be able to use these lifts alone, manually rotating themselves while on the seat.







Model AG48WP Above-Ground, Wood Post Mount, Lifts over 48" Wall
 Usually Assisted Operation    Lifts up to 300 lbs. at 55 psi
 Manual 360° Seat Turn        Vertical Seat Travel -- 31 "
 Water-Pressure Powered       Installs on Wood Post in Ground
 The AG48WP mounts to a wood post sunk 30 in the ground and cut off at pool wall height. This lift is usually assistant-operated. Some people will be able to use the AG48WP independently with an optional stationary handle (shown) to manually push / pull themselves while  on the seat. Independent users would rotate  themselves close to the pool wall, then lift their legs one at a time over the wall. The standard seat has two arms.









Model AG72 Above-Ground, Lifts over 72" Wall
 Assisted Operation                Lifts up to 300 lbs. at 55 psi
 Manual360° Seat Turn           Vertical Seat Travel-5 1't
 Water-Pressure Powered       Installs on Deck and at top pool flange
The Pool Lift Model AG72    lifts up to 300 lbs. at 55 psi and is assistant-operated.  It was  specifically designed to lift people into and out of  above-ground therapy pools with 5' - 6' tall walls. After raising the seat, the assistant turns the seat while helping to lift the patient's legs,  then turns the valve handle to lower the seat inside the pool. The stainless steel plate at the base of the cylinder is bolted to the floor  and a  stainless steel bracket around the top of the cylinder is bolted through the top pool flange. The standard seat has two arms.








ACCESSORIES
  Flip-up left outer arm (shown in raised position)
 Headrest-- soft, full support, with adjustable height
 Seat belts -- seats slotted for chest and lap locations
 Vinyl-liner pool wall pad for IGAT models -- prevents rubbing on liner (not shown)
 Extra recessed sockets and socket covers -- to allow use in other locations (not shown)